|
|
Fiberglass Surface Prep
Fiberglass Surface Prep,
YMA601 is the first step in a 2step system for removing mold release
agents, waxes and grease from gelcoat prior to application of antifouling
paint. The pigmented formula acts as a guide during the cleaning
process.
Applies easily with Scotch-Brite pad. Rinse with fresh water or wipe clean
to remove. Abrasive properties of the Fiberglass Surface Prep
thoroughly cleans the gelcoat and provides key for a long lasting finish. |
|
Part No. |
Description
(Click to view & order) |
Price |
| Fibreglass
Surface Prep is a mould release agent remover which precludes the need
for sanding bare GRP when used with International's Fibreglass No Sand
Primer or Interspeed Aqua. Fibreglass Surface Prep thoroughly cleans the
gelcoat and provides a key for Fibreglass No Sand Primer or Interspeed
Aqua to be applied. Can be used to prepare aged and weathered alkyds
prior to application of subsequent coats by softening the surface
slightly. |
| Method |
Apply
Fibreglass Surface Prep to a damp cloth or sponge, then wipe the whole
surface to be cleaned using moderate pressure. Wipe off with a clean,
wet cloth ensuring no traces of Fibreglass Surface Prep remain. As soon
as the surface is dry, it is ready to paint. BARE GRP: If the
overcoating time exceeds 4 hours, ensure that the surface is clean and
dry prior to subsequent application of the paint. ALKYDS: If the
overcoating time exceeds 4 hours, re-apply Fibreglass Surface Prep prior
to subsequent overcoating. |
|
|
| Hints |
Mixing Stir
or shake thoroughly.
Other Fibreglass Surface Prep will not remove serious blemishes. |
|
|
| Some
Important Points |
Protect
from frost. |
|
|
| Compatibility/Substrates |
GRP
only. |
|
|
|
|
| Recommended
DFT |
|
| Application
Methods |
Cloth/Sponge |
|
| TRANSPORTATION,STORAGE
AND SAFETY INFORMATION |
| Storage |
GENERAL
INFORMATION:
Exposure to air and extremes of temperature should be avoided. For the
full shelf life of Fibreglass Surface Prep to be realised ensure that
between use the container is firmly closed and the temperature is
between 5°C/40°F and 35°C/95°F. Keep out of direct sunlight.
TRANSPORTATION:
Fibreglass Surface Prep should be kept in securely closed containers
during transport and storage.
|
|
|
| Safety |
GENERAL:
Read the label safety section for Health and Safety Information, also
available from our Technical Help Line.
DISPOSAL: Do not discard tins or pour paint into water courses, use the
facilities provided. It is best to allow paints to harden before
disposal.
Remainders of Fibreglass Surface Prep cannot be disposed of through the
municipal waste route or dumped without permit. Disposal of remainders
must be arranged for in consultation with the authorities.
|
|
